Our custom racks are compatible with all Plombco adhesive wheel weight boxes. Each rack is easy to setup, simplifies managing your inventory and helps reduce the time it takes for a technician to properly balance a wheel.
-
Single Hanging Rack / H1
-
-
Part number: 50286
-
-
-
Triple floor stand rack/ FS3
-
-
Part number: 50287
-
-
-
Double Hanging rack / H2
-
-
Part number: 50288
-
-
Installation instructions
Step 1
Hang the Plombco adhesive wheel rack onto the balancer.
Step 2
Insert the box of adhesive wheel weights in the upright position facing forward.
Step 3
Remove the protective transport adhesive tape from the box.
Step 4
Pull down on the wheel weight adhesive strip and it is ready for use.
Note: Always leave 6 inches of the adhesive strip visible to avoid retraction back into the box.